UK Karting - Notice Board (Combined Forum) : Re: MS Prokart

Notice Board (Combined Forum)

Re: MS Prokart
Posted by 'Eddy' on 14 Nov 2015 @ 09:35

| View Message Thread | Reply to this message |

EddyJoined: August 2009
Total Posts: 47
[ View User Profile ]

For base set-up try this.
Front, loosen the slider plate, wants to be nearly as far forward as it will go (just half covering the set screw that holds the plate down at the front)
The bottom of the yoke should be the older type disk with lots of holes in, the pop point on this wants to be facing to the rear
The side-to-side set-screws want to be ½ to 2/3 to the centre of the chassis (lasers are easier for this)
About 1 degree toe-out
Rear about 155mm
This is a base set-up, depends on track, driver, whether, tyres all chassis are a bit different but that is a good starting point

Message Thread:

MS Prokart by 'gk43' (13 Nov 2015 @ 22:30)

Re: MS Prokart by 'Eddy' << You are here!

Re: MS Prokart by 'gk43' (14 Nov 2015 @ 18:25)

Re: MS Prokart by 'Eddy' (15 Nov 2015 @ 9:57)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links