UK Karting - Notice Board (Combined Forum) : Re: Prokart chain set up.

Notice Board (Combined Forum)

Re: Prokart chain set up.
Posted by 'd-i-y71' on 09 Oct 2014 @ 21:55

| View Message Thread | Reply to this message |

d-i-y71Joined: September 2009
Total Posts: 198
[ View User Profile ]

In theory you should position the engines to give weight distribution 40% front. 60% rear.to 45% front 55% rear with you in the kart fully kitted out, measured with scales or balancing the kart on a knife edge. In practice you will probably find you haven't too much scope for moving them and weight distribution will be okay anyway.Next factor is gearing ,you will probably have 20 tooth clutches and back sprocket will be around70t .So clamp the engines where you want them and fit the right sprockets. Split the inboard one with a hacksaw to fit it.Take a length of chain,any length, but not joined into a loop.split one if you need to.Count the rollers. Put the chain round the clutch sprocket and over the rear sprocket. It will be either too long overlapping or too short leaving a gap on the sprocket . Count how many rollers more or less you need on your actual chain compared with your test chain and split to suit. You will need to re rivet the inboard chain in position. The outboard one you can rivet and slacken the engine to fit.ATBOL

Message Thread:

Prokart chain set up. by 'steve65' (09 Oct 2014 @ 20:12)

Re: Prokart chain set up. by 'd-i-y71' << You are here!

Re: Prokart chain set up. by 'steve65' (10 Oct 2014 @ 16:46)

Re: Prokart chain set up. by 'harry07' (02 Nov 2014 @ 9:51)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links