UK Karting - Notice Board (Combined Forum) : Re: Central fuel tank conversion

Notice Board (Combined Forum)

Re: Central fuel tank conversion
Posted by 'd-i-y71' on 09 Aug 2014 @ 13:54

| View Message Thread | Reply to this message |

d-i-y71Joined: September 2009
Total Posts: 198
[ View User Profile ]

"Prise off circlip from plastic gear assembly" The circlip in question is a rather nasty wire snap ring on the gear spindle which I always found impossible to remove. Apparently the gear can be removed rather brutally with a large pair of pliers. My method was to remove the flywheel and knock the spindle through into the crankcase with a suitable punch. (Don't be too vicious), slide off the unwanted bits, shorten the spindle and loctite back into position. As Brian says there are 2 or 3 steel washers to be retrieved as well as the nylon plunger. Note that Honda leave razor sharp edges on the crankcase which you are not allowed to remove without annoying msa.

Message Thread:

Central fuel tank conversion by 'BigSlick' (08 Aug 2014 @ 22:22)

Re: Central fuel tank conversion by 'BrianP' (09 Aug 2014 @ 6:42)

Re: Central fuel tank conversion by 'd-i-y71' << You are here!

Re: Central fuel tank conversion by 'BigSlick' (10 Aug 2014 @ 15:06)

Re: Central fuel tank conversion by 'lard ass bob' (10 Aug 2014 @ 15:54)

Re: Central fuel tank conversion by 'BigSlick' (10 Aug 2014 @ 17:38)

Re: Central fuel tank conversion by 'Jeff Johnson' (10 Aug 2014 @ 21:52)

Re: Central fuel tank conversion by 'lard ass bob' (10 Aug 2014 @ 22:39)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links