UK Karting - Notice Board (4-Stroke Karting) : Re: will a Honda gx160 fit on to an arrow ax-9

Notice Board (4-Stroke Karting)

Re: will a Honda gx160 fit on to an arrow ax-9
Posted by 'wildcard' on 18 Apr 2011 @ 19:06

| View Message Thread | Reply to this message |

wildcardJoined: November 2007
Total Posts: 1
[ View User Profile ]

Hi,

We run an AX9 in Honda cadet for two years and we had no problems with it. I used to cut the sprocket to allow it to be opened up over the axle. I also used to hang a spare chain from the rear bumper to the back of the seat, so that if we need to replace it during a meeting I would not have to remove the axle. You will also need to have a keyway cut into the axle inside the bearing on the right hand side to take the drive sprocket and carrier. We had a great couple of years at club level with the AX9, It would have been more than capable of winning at national level, but I was not going to spend the big money wanted for a 200 quid engine.
The Ax9 is a strong chassis and looked after my son well. I am a little jealous of you the AX9 was a great chassis only wish we had the engine to do it justice.
Good luck

Message Thread:

will a Honda gx160 fit on to an arrow ax-9 by 'dutchmansdad' (17 Apr 2011 @ 21:26)

Re: will a Honda gx160 fit on to an arrow ax-9 by 'fatboynobby' (17 Apr 2011 @ 22:28)

Re: will a Honda gx160 fit on to an arrow ax-9 by 'danboysdad' (18 Apr 2011 @ 9:58)

Re: will a Honda gx160 fit on to an arrow ax-9 by 'wildcard' << You are here!

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links