UK Karting - Notice Board (4-Stroke Karting) : Re: end float on clutch

Notice Board (4-Stroke Karting)

Re: end float on clutch
Posted by 'lard ass bob' on 03 Sep 2009 @ 08:51

| View Message Thread | Reply to this message |

lard ass bobJoined: August 2001
Total Posts: 41
[ View User Profile ]

Not used a stud and nut is years Trev - I have always found the supplied bolt and washer to be fine.

Float should be small - 1mm even. More often than not (unless the French based Know-it-all says otherwise of course) using the washers, spacer, keyway and bolt supplied with the clutches these days achieves a well positioned fit.

Graeme

Message Thread:

end float on clutch by 'ryan' (02 Sep 2009 @ 22:42)

Re: end float on clutch by 'Trev' (02 Sep 2009 @ 22:55)

Re: end float on clutch by 'lard ass bob' << You are here!

Re: end float on clutch "Agincourt" by 'Trev' (03 Sep 2009 @ 17:00)

A two fingered salute to you, ala Agincourt. by 'RoadRat' (03 Sep 2009 @ 19:24)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links