UK Karting - Notice Board (2-Stroke Karting) : the new rotax clutch advice

Notice Board (2-Stroke Karting)

the new rotax clutch advice
Posted by 'adey8ball' on 25 Feb 2009 @ 18:20

| View Message Thread | Reply to this message |

adey8ballJoined: August 2007
Total Posts: 1
[ View User Profile ]

hello there

bit the bullet and bought a new clutch which was fitted on the weekend and used at the 1st dunks meeting.

a couple of questions

when the clutch bolts were being tightened to the 20mn advised in the book, 2 of the bolts broke. one snapped clean away and the other sheared considerably. because of this i dont want to to keep taking the block on and off without a supply of bolts ready in case they break again. i believe the bolt is a allen screw M6X16mm. can i buy lots of these bolts from a nut nad bolt supplier or are these bolts made from a specific material and should only buy from a kart shop.

what maintenance do i need to do to the new clutch. i assume brake clean the block and backplate and drum. do you need to blow through the block cuts.

any help greatly appreciated

thanks

adrian

Message Thread:

the new rotax clutch advice by 'adey8ball' << You are here!

Re: the new rotax clutch advice by 'stephenc47' (25 Feb 2009 @ 18:42)

Re: the new rotax clutch advice by 'ijsjs' (25 Feb 2009 @ 19:30)

Re: the new rotax clutch advice by 'ijsjs' (25 Feb 2009 @ 19:45)

Re: the new rotax clutch advice by 'John' (26 Feb 2009 @ 0:18)

Re: the new rotax clutch advice by 'adey8ball' (26 Feb 2009 @ 1:27)

Re: the new rotax clutch advice by 'John' (26 Feb 2009 @ 7:57)

Re: the new rotax clutch advice by 'ijsjs' (26 Feb 2009 @ 11:46)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links