Hi Thomas, all done and dusted. Temp sensors arrived this morning (cheers Shaun). New oil filter housing hasn't arrive from Saxon yet so I've modded the original. Drilled through top of housing, 9mm, and tapM10x1.0. PTFE applied applied to sensor and sensor screwed in. Now this is where I was cautious, not wanting to. over tighten in fear of splitting the housing, but not wanting leaks! All fitted back on engine and run watching for leaks, shut down after a minute or so. Lead attached from sensor to ebox and Mychron switched on to reveal two temperatures on screen, so far so good. Engine run and watched temperatures rise steadily. I then set warning light to come on for test purposes at 25c, engine run again and warning light came on at correct temp, result! Thursday night is test night, I'll run for a while and observe the usual oil temp and then set warning light 5c above that. Worthy addition I believe. Andy
|
|