|
you want to do.
I've used a GX200 but you may need a few workarounds.
Firstly, you will probably have to cut the rear engine mount on its inside , so that it clears the cross chassis rail.
You may have to make a couple of spacer bars to raise the engine on the mounts so that it clears the rear bearing hanger.
You may have to tweek the seat mounting stay so that the engine clutch bolt clears to allow the engine to slide up and down for chain adjustment.
The axle must have an inboard keyway for the sprocket carrier and you may have to change the carrier for one that lets you mount the sprocket on either side of the carrier.
I'll take some pictures of what i've done and if you email me your email, I'll post them to you.
alan@anita.co.uk
My mobile is 07759361238 in case you need it.
|
|
|