UK Karting - Notice Board (Combined Forum) : survey of bumper/chassis measurements

Notice Board (Combined Forum)

survey of bumper/chassis measurements
Posted by 'IamSpartacus' on 19 Dec 2015 @ 12:03

| View Message Thread | Reply to this message |

IamSpartacusJoined: July 2009
Total Posts: 31
[ View User Profile ]

I'm seeking measurements across differing chassis of the distance between the rear of the lower bumper and the front edge of the chassis tubing.

A clause of the 2016 Homologation Regulations 8.2.1 Bodywork & Bumpers (protection) states "... maximum dynamic intrusion : forbidden zone of 40mm measured ahead of the front tube contour..."

The dynamic behaviour of the new fairing mounting kit 1/CA/20 01/01 ET is for it to slide backwards towards this forbidden zone, by around 30mm.

In other words if your bumper/chassis gap is less than (about) 70mm your setup will violate the crash test requirements and obviously be unsafe.

So besides a 10 place penalty you may also fail post-race scruiteneering.

Please post your make & model and gap.

Message Thread:

survey of bumper/chassis measurements by 'IamSpartacus' << You are here!

Re: survey of bumper/chassis measurements by 'bt3962' (20 Dec 2015 @ 4:26)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links