UK Karting - Notice Board (Combined Forum) : Re: Stub Axle Bearings

Notice Board (Combined Forum)

Re: Stub Axle Bearings
Posted by 'SimonS' on 01 Jan 2015 @ 22:45

| View Message Thread | Reply to this message |

SimonSJoined: December 2004
Total Posts: 4
[ View User Profile ]

Obviously you need to find a bearing with the same outside diameter as your current 8mm bearing

so if your current bearing is a 608zz it has an ID of 8mm and OD of 22 mm and a length of 7mm

A quick search of simply bearings produces a

W61900 2Z which is a 10mm ID, 22mmOD but only 6 mm long.

Also, most stub axles have 4 bearings in the kingpin, 2 at either end, and a separator that runs between the bearing sets.

You could run the narrower 10mm bearings, making sure they seated properly on the internal seat, but it would be best to make up the internal separator as well ( a piece of 10 mm ID tube) to support the inboard races.

Your other problem will be that you need to find extra yoke spacers, because your bearing stack will now be 2 mm shorter top and bottom (ie 2* 6mm long bearings wher you had 2 by 7mm bearings).

Not impossible, in fact quite easy....but if you don't have any mechanicing skills at the moment you might feel challenged!

Message Thread:

Stub Axle Bearings by 'Sully' (01 Jan 2015 @ 20:06)

Re: Stub Axle Bearings by 'SimonS' << You are here!

Re: Stub Axle Bearings by 'Eddy' (02 Jan 2015 @ 19:38)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links