UK Karting - Notice Board (Combined Forum) : Re: Brass Throttle screw

Notice Board (Combined Forum)

Re: Brass Throttle screw
Posted by 'SimonS' on 04 Feb 2009 @ 14:59

| View Message Thread | Reply to this message |

SimonSJoined: December 2004
Total Posts: 4
[ View User Profile ]

Normally the stud of the clamp has been pushed through the throttle arm and the end then turned over as a rivet to hold the assembly in place.

So you cannot usually buy the clamp on its own.

However there is no reason (apart from "it's a modification of the carburettor and thus not allowed") why you should secure a similar clamp in place with a (brass) bolt that has been loctited in place.

Indeed you should be able to make the clamp with only handtools (a drill and some taps) and get the bolts from EKP Supplies (http://www.ekp.supplies.btinternet.co.uk/). No doubt you can get the screws elsewhere but EKP are karters too and might be abble to make you up a handful.

Message Thread:

Brass Throttle screw by 'Dude' (04 Feb 2009 @ 11:34)

Re: Brass Throttle screw by 'HC64' (04 Feb 2009 @ 13:09)

Re: Brass Throttle screw by 'SimonS' << You are here!

Re: Brass Throttle screw by 'Herbie53' (05 Feb 2009 @ 8:37)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links