Fantastic. Be careful with the seat position too. Most people put them in the Zip chassis far too rearwards, the magic dimension nowdays is 170-175mm, in both a P1 or a Synergy, same applies for a ZIP. measured diagonal from the back face of the seat to the edge of the 25mm axle. if it measures 140-150mm then re-drill all 4 mounting points and move the seat forwards, it's worth a lot of time.
Always run your lad at 103kg, put 2kg on the floor in front of the tank. 4kg under the front lip of the seat, put the rest on the side of the seat......do NOT put any weight on the rear of the seat.....yes loads of people do, because they are lazy, it's the worst place to put lead.
If you need any help with your engine contact me via www.KnighTorque.co.uk based in Essex.
|
|