UK Karting - Notice Board (2-Stroke Karting) : Re: Float arm height on Junior Rotax

Notice Board (2-Stroke Karting)

Re: Float arm height on Junior Rotax
Posted by 'mlbeave' on 11 May 2009 @ 22:53

| View Message Thread | Reply to this message |

mlbeaveJoined: April 2007
Total Posts: 1
[ View User Profile ]

mis firing at the top end usually means your to lean,so go up a jet,or move the clip down a notch on the needle.
if you raise the float hight to 6mm it will run even leaner as thiers less fuel in the float bowl.

mark

Message Thread:

Float arm height on Junior Rotax by 'rossi46' (11 May 2009 @ 18:16)

Re: Float arm height on Junior Rotax by 'Hootsman' (11 May 2009 @ 19:35)

Re: Float arm height on Junior Rotax by 'WayneWillet' (11 May 2009 @ 19:58)

Re: Float arm height on Junior Rotax by 'David1974' (11 May 2009 @ 21:48)

Re: Float arm height on Junior Rotax by 'mlbeave' << You are here!

Re: Float arm height on Junior Rotax by 'gettingquicker' (11 May 2009 @ 23:07)

Re: Float arm height on Junior Rotax by 'rossi46' (12 May 2009 @ 10:18)

Re: Float arm height on Junior Rotax by 'dad99' (12 May 2009 @ 11:14)

Re: Float arm height on Junior Rotax by 'mlbeave' (12 May 2009 @ 16:57)

Re: Float arm height on Junior Rotax by 'rossi46' (13 May 2009 @ 10:09)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links