UK Karting - Notice Board (General Karting) : Re: Bleeding TKM Veloce 2011 brakes

Notice Board (General Karting)

Re: Bleeding TKM Veloce 2011 brakes
Posted by 'Farrang' on 17 Dec 2012 @ 17:33

| View Message Thread | Reply to this message |

FarrangJoined: August 2001
Total Posts: 1
[ View User Profile ]

1.Remove linkage from master cylinder.
2.Remove master cylinder.
3.loosen screws on cover.
4.take diaphragm out.
5.fill master cylinder with fluid.
6.elevate master cylinder higher than caliper.
7.fit fuel pipe to bleed screw on caliper and undo. loosen bleed screw.
8.whilst keeping master cylinder topped up let fluid run until no air bubbles are present.
9.repeat with other side of caliper.
10.Finally fill master cylinder up, replace diaphragm and cover.

Make sure you have the master cylinder filled right up at the end. Sounds fiddly but it really isn't if you plan it properly, takes about twenty mins and is very simple.

I loosened and retightened all the bits i needed to before hand so i knew everything would loosen without struggling halfway through.

Message Thread:

Bleeding TKM Veloce 2011 brakes by 'GR2' (17 Dec 2012 @ 14:49)

Re: Bleeding TKM Veloce 2011 brakes by 'Farrang' << You are here!

Re: Bleeding TKM Veloce 2011 brakes by 'Farrang' (17 Dec 2012 @ 17:40)

Re: Bleeding TKM Veloce 2011 brakes - fluid type? by 'GR2' (20 Dec 2012 @ 15:30)

Re: Bleeding TKM Veloce 2011 brakes - fluid type? by 'Farrang' (20 Dec 2012 @ 23:27)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links