UK Karting - Notice Board (General Karting) : Re: 50mm hubs question

Notice Board (General Karting)

Re: 50mm hubs question
Posted by 'UrbanTiger' on 15 Jun 2010 @ 22:16

| View Message Thread | Reply to this message |

UrbanTigerJoined: February 2002
Total Posts: 1
[ View User Profile ]

The retaining device is to prevent the hub from sliding off the axle not further on.
Taking iant's point, you are right about the wheel orifice and thinking about this further, the PCD of the hub studs is probably around 50mm and machining too close to these would weaken the hub rendering it dangerous IMO

Message Thread:

50mm hubs question by 'stemorton46' (13 Jun 2010 @ 20:24)

Re: 50mm hubs question by 'UrbanTiger' (13 Jun 2010 @ 22:12)

Re: 50mm hubs question by 'stemorton46' (13 Jun 2010 @ 22:16)

Re: 50mm hubs question by 'SimonS' (13 Jun 2010 @ 22:23)

Re: 50mm hubs question by 'UrbanTiger' (13 Jun 2010 @ 22:25)

Re: 50mm hubs question by 'stemorton46' (13 Jun 2010 @ 22:27)

Re: 50mm hubs question by 'Aquila' (13 Jun 2010 @ 22:35)

Re: 50mm hubs question by 'UrbanTiger' (13 Jun 2010 @ 22:39)

Re: 50mm hubs question by 'iant' (13 Jun 2010 @ 23:52)

Re: 50mm hubs question by 'Ditch' (14 Jun 2010 @ 3:39)

Re: 50mm hubs question by 'TFowler' (15 Jun 2010 @ 17:35)

Re: 50mm hubs question by 'UrbanTiger' << You are here!

Re: 50mm hubs question by 'iant' (16 Jun 2010 @ 19:50)

Re: 50mm hubs question by 'Ditch' (16 Jun 2010 @ 21:38)

Re: 50mm hubs question by 'iant' (16 Jun 2010 @ 21:54)

Re: 50mm hubs question by 'UrbanTiger' (16 Jun 2010 @ 22:00)

Re: 50mm hubs question by 'iant' (16 Jun 2010 @ 23:47)

Re: 50mm hubs question by 'Ditch' (17 Jun 2010 @ 1:06)

Post a Reply:

You may post a direct reply to this message which will appear in this thread.
To post a new or unrelated message use This Form. Top of Page
Notice Board Index

[ UK Karting Main Index ]


News	Karts & Karting	Notice Board	Market Place	Companies Directory	Tracks Directory	Events Calendar	Race Results	Photo Gallery	Links